Rational oven cleaning aborted or not cleaning properly: causes and fixes
When a RATIONAL combi oven aborts its cleaning cycle, or finishes it with the tablets still undissolved and the cabinet still dirty, the cause is usually in the cleaning water circuit: the rinse or cleaning pump, the ball valve that directs the water, the spray jets, or a blocked drain. LE Company engineers repair RATIONAL ovens across London, and these are the faults we have found on ovens that would not clean.

Why is my Rational oven cleaning aborted?
1. The pump
A broken rinse pump stops the washing cycle from finishing; on one oven no further tests were possible until we replaced it. On an iCombi Pro in a London hotel kitchen that stopped mid-clean with Service 110, an automation error during cleaning, we replaced the pump housing; read commercial kitchen equipment repair: what breaks and why for that job. A pump impeller can also block with food and grease, as in the photo below from a SelfCookingCenter.

2. The ball valve
The ball valve switches the water between cleaning and draining. We have found pieces of plastic in the washing container and the ball valve, which had damaged the ball valve motor, and on an oven showing Service 26 a ball valve that sometimes did not respond because water had got into its main connection; we dried and reconnected it.
3. The spray jets and jet rails
If the jets do not spray, the cleaner never reaches the cabinet. We have found a spray jet that did not work because its magnet was faulty, and jet rail connections that leaked under the door.
4. Drains, waste pipes and water supply
A blocked waste pipe or rinse pump pipe stops the oven draining, and the cycle fails. We clean the waste and rinse pump pipes as part of an emergency visit. Low water pressure can also stop the cycle; and scale matters here too, as our job on a steam generator full of scale with the cleaning interrupted shows.
Rational cleaning tablets not dissolving
If the tablets are still whole after a cleaning cycle, the oven is not circulating enough water over them. On one oven with exactly this complaint we advised replacing the rinse pump. Use only genuine RATIONAL tablets, put them where the oven tells you, and do not add more to make up for a weak pump: the pump needs testing.

The cleaner the oven expects is set in its expert settings, as on this SelfCookingCenter XS: Active Green cleaner yes, NaOH-free cleaner no, fat drain signal before cleaning off. If the setting does not match the tablets you use, the programme will not clean as it should.
What to do when a Rational cleaning cycle aborts
- Note the Service code on the display, for example Service 25 (no water flow during cleaning), Service 26 or Service 110.
- Check the water tap to the oven is fully open and the drain is not blocked.
- Do not keep restarting the cycle with more tablets: a pump, valve or jet fault will not clear by itself.
- Book an engineer, and see RATIONAL error codes explained for what each code means.
See our RATIONAL oven repair in London page, Rational oven not steaming: causes and fixes, commercial oven repair and commercial kitchen equipment repair in London.
Questions
Why does my Rational oven abort the cleaning cycle?
Most often a fault in the cleaning water circuit: a broken rinse or cleaning pump, a ball valve that does not respond, spray jets that do not spray, or a blocked drain or waste pipe. Low water pressure can also stop it. The Service code on the display shows where to look.
Why are the cleaning tablets not dissolving in my Rational?
Not enough water is circulating over them, usually because the rinse pump is weak or failing. On one RATIONAL oven with this complaint, LE Company advised replacing the rinse pump.
What is Service 110 on a Rational iCombi Pro?
An SC automation error during cleaning; the oven stops in an interrupted cleaning cycle and is not in operation. On an iCombi Pro in a London hotel kitchen, LE Company engineers replaced the pump housing.
Can I keep using a Rational oven if cleaning fails?
Usually you can keep cooking, but the cabinet will not be cleaned automatically and the fault will not clear by itself. Book a repair rather than restarting the cycle again and again.
Book a RATIONAL engineer in London
LE Company’s engineers are RATIONAL certified and Gas Safe registered. The call-out is from £175 + VAT and includes the first 30 minutes on site, when the engineer finds the cause; the cost of any repair is agreed with you before work starts, and we fit only genuine RATIONAL parts. For an emergency we dispatch an engineer within an hour and aim to be with you within 4 hours, traffic permitting. Call +44 203 603 7172.